Boning Knives ~ Wildfire Cutlery ~ Michael Moses Lishinsky ~ Carbon steel kitchen knives

Boning Knives
animated-butterfly4


Current Prices Boning Knives
6” x 1.5” – $ 121
12” x 2.5” – $ 198
12″ is made from 3/32nd inch thick 1095 tool steel

I also make an Asian inspired version of a Boning Knife I called a Hankotsu ⇐ see here.

Traditionally, boning knives have been used to butcher animals, that were either hanging, on the ground or a table. They generally had a bold sweep to their edge, which allowed one to make short slices with the curved tip along the seam between the hide and then fascia.
I have taken the best aspects of traditional designs and included them in my boning knives. I have mostly been asked to create long and short boning knives, but I can make one of any length that you like, or of thicker steel.
I use strictly high carbon tool steel, that is 1/16″ thick. Notice my company chop in the butt of the handle. It is composed of 1/4″ aluminum tube filled with 4 - 1/16th” brass rods inside a square tube of brass and aluminum outside, all is filled with red dyed epoxy that is injected. At the center in the middle of those rods (at the center of this 12″ long tube), is a slice of lions hair piano wire. The tube is made in 12″ sections and sliced. The other rivets are 1/8″ brass road glued right through the full-tanged handle and pressed in at a slight bias.


Image is not available
3" Traditional Paring knife.
12" x 2.5" Scimitar shaped Boning, Manzanita.
Double brass, 12" x 2.5" scimitar Boning Knife
10", Rosewood, 1999
8" Boning, stabilized Maple, b/w spacers.
ArrowArrow
ArrowArrow
Ray's Boning knife set - client designed completely. - Old Walnut wood, 12" x 2.5" scimitar shaped Boning knife, Carbon steel, brass bolsters. R/B/R 1/8" bolster spacers. Bottom is 7" x 1.25" scimitar shaped Boning knife.
Shadow
ArrowArrow
Slider